#PADLOCK WITH CHANGEABLE CODE HOW TO#
#PADLOCK WITH CHANGEABLE CODE FULL#

Remove knob assembly, check if notches of tumbler 3 and 2 are lined up with the right arm of the latch. Turn knob 1 complete turn counter clockwise and continue turning until you reach the second number of you combination.

#PADLOCK WITH CHANGEABLE CODE FULL#

Turn Knob at least 2 full turns clockwise then continue turning clockwise until you reach your first number. If not your position of the knob and tumbler 1 is incorrect or the the tumbler pegs in tumbler 1 and/or tumbler 2 are wrong.Ģ) Reinsert Knob assembly. The notch on tumbler 3 should be lined up with the right arm of the latch.

Remove the knob and look at tumbler 3 (the bottom one). If your combination doesn't work go through these steps.ġ) Turn Knob at least 2 full turns clockwise then continue turning clockwise until you reach your first number. When the last number of the combination is reached the Latch left arm should move away from the shackle. This is a good time to test you combination numbers to make sure it works. Make sure the knob turns freely on the base tumbler shaft. Step 8: Insert Knob with tumbler 1 assembly onto the base tumbler shaft with the notch of the tumbler pointed toward the Latch right arm, as shown. Though not shown in the pictures, it is also better to pull the short end of the Shackle out of the Base. This makes it easier to perform the next step of installing the Latch.

Make sure Tumbler 2 spins freely on the Spacer.Īt this point rotate both Tumbler 3 and Tumbler 2 so that the notches are pointed directly to the left side of the base. Step 4: Insert Tumbler 2 onto the Bases tumbler shaft with the groove up, then insert the other Spacer onto the bases tumbler shaft just like Assembly Step 2. The picture 'Assembly Step 3' shows the peg inserted in position 4. Please note that position 0 can not be used, the lock will not function properly.

#PADLOCK WITH CHANGEABLE CODE HOW TO#

Later in this Instructable will show how to know which position to insert the tumbler peg depending on the combination numbers desired. In this step the position effects only the 1st number of the combination. There are 10 different positions, position 0 is considered to be the peg directly under the notch of the tumbler and is counted up in a clockwise direction.

Step 3: Insert one of the Tumbler Pegs into Tumbler 2.

Padlock with changeable code